Setup Instructions

STEP 1

Unbox your Restore Tub and Chiller

1. Unpack the Restore Tub and Chiller from their respective shipping cartons and remove any protective wrapping.

2. Select a stable and smooth surface with plenty of room for ventilation.

3. Make sure a water source and 110/120V AC socket that is properly grounded are accessible.

*If setting up outdoors, we recommend setting up under a sheltered/covered area to ensure the longevity of your product.

STEP 2

Setting up your Restore Tub

1. Unfold your tub in your desired location.

2. Inflate the tub using the double action air pump included, ensuring that the inflating hose is connected to the inflate side of the pump.

3. Open the inflation valve cap by rotating counterclockwise. Make sure the inflation valve pin on the tub is in an "out" position and not pushed in, or will air will be released after the inflation hose from the pump is detached.

4. Connect the inflation hose to the valve by plugging it in and giving it a quarter turn clockwise. Inflate until the gauge on the pump reaches 8 PSI. DO NOT over inflate or product damage may occur.

5. When done inflating, reconnect the inflation valve with a clockwise turn.

6. Connect the inflation hose to the tub lid and repeat steps 3-5.

7. Attach the White PVC Fittings to the Tub “water out” (red), and “water in” (green) fittings by rotating it clockwise until hand tight. Do not tighten with tools.

STEP 2

Connecting your Chiller to the Tub

1. First check that there is at least 12’’ between the chiller and the wall for proper air flow.

2. The green “Water In” fitting on the Tub should connect to the green "Outlet” on the Chiller. The red “Water Out” fitting on the Tub should connect to the red "Inlet” filter on the Chiller.

STEP 3

Filling the Tub

1. Fill until the water is roughly 15 cm (6 inches) below the underside of the top ring (not more than ⅔ full). Make sure the water level is above the top inlet of the Tub. Overfilling may cause water to overflow from the Tub for some users, though you may fill to your preference.

STEP 4

Powering on your Chiller

1. Plug the Chiller into a standard 110v/120v properly grounded AC socket or extension cable that is suitable for use, has a built in surge protector and preferably is IP65 rated.

2. You may now turn on the Chiller by pressing the “Power” button on the display screen. The Chiller may take up to 2-3 minutes to purge air from the system.

STEP 5

Setting the Temperature

1. Press the "Set" button to enter the setting temperature menu.

2. Press the "up" key or "down" key, to adjust the desired temperature. Once the desired temperature is set, wait 2-3 seconds until the display shows the main menu, then your temperature is set. Once the chiller has finished its priming cycle it will start to chill and filter the water within a few minutes.

3. Once the desired temperature is reached, switch off the Chiller/Heater Unit before starting your cold water therapy session.